ASTM C508/C508M-00(2009)e1 - 1.11.2009
 
1. Scope

1.1 This specification covers asbestos-cement perforated and plain pipe intended for use in the conveyance of drainage water for the subsurface drainage of highways, airports, farms, foundations, and other similar drainage work.

1.2 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

MIL-STD-129

Marking for Shipment and Storage

No. 123

Marking for Shipment Civil Agencies Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.

D2946-01

Standard Terminology for Asbestos and Asbestos-Cement Products

C618-26

Standard Specification for Coal Ash and Raw or Calcined Natural Pozzolan for Use in Concrete

C500-C500M-07(2011)e1

Standard Test Methods for Asbestos-Cement Pipe

C150/C150M-24

Standard Specification for Portland Cement

C608-71

Method of Test for Brittle Ring Tensile Strength of Chemically Setting Silicate and Silica Chemical-Resistant Mortars (Withdrawn 1983)

C595/C595M-26

Standard Specification for Blended Hydraulic Cements

C458-C458M-98(2011)e1

Standard Test Method for Organic Fiber Content of Asbestos-Cement Products