ASTM C547-03 - 10.4.2003
 
1. Scope

1.1 This specification covers mineral fiber insulation produced to form hollow cylinders for standard pipe and tubing sizes. The mineral fiber pipe insulation may be molded or precision v-grooved, with one or more walls split longitudinally for use on pipe temperatures up to 1200°F (650°C).

1.2 For satisfactory performance, properly installed protective vapor retarders or barriers should be used on sub-ambient temperature applications to reduce movement of moisture through or around the insulation to the colder surface. Failure to use a vapor barrier can lead to insulation and system damage. Refer to Practice C 921 to aid material selection.

1.3 Flexible mineral fiber wrap products such as perpendicular-oriented fiber insulation rolls, non-precision or manually scored block or board, or flexible boards or blankets used as pipe insulation, are not covered by this specification.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 The following safety hazards caveat applies to the test methods portion, Section 11, only: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

C356-22

Standard Test Method for Linear Shrinkage of Preformed High-Temperature Thermal Insulation Subjected to Soaking Heat

C447-15(2022)

Standard Practice for Estimating the Maximum Use Temperature of Thermal Insulations

C302-13(2022)

Standard Test Method for Density and Dimensions of Preformed Pipe-Covering-Type Thermal Insulation

C177-19(2026)

Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus

C168-25

Standard Terminology Relating to Thermal Insulation

C167-25

Standard Test Methods for Thickness and Density of Blanket or Batt Thermal Insulations

C335/C335M-23

Standard Test Method for Steady-State Heat Transfer Properties of Pipe Insulation

C390-08(2024)

Standard Practice for Sampling and Acceptance of Thermal Insulation Lots

C411-26

Standard Test Method for Hot-Surface Performance of High-Temperature Thermal Insulation

E84-26a

Standard Test Method for Surface Burning Characteristics of Building Materials (Includes all amendments and changes 4/15/2026).

C1104/C1104M-19(2025)

Standard Test Method for Determining the Water Vapor Sorption of Unfaced Mineral Fiber Insulation

C1058/C1058M-10(2023)

Standard Practice for Selecting Temperatures for Evaluating and Reporting Thermal Properties of Thermal Insulation

C1045-19(2026)

Standard Practice for Calculating Thermal Transmission Properties Under Steady-State Conditions

C921-10

Standard Practice for Determining the Properties of Jacketing Materials for Thermal Insulation

C795-08(2023)

Standard Specification for Thermal Insulation for Use in Contact with Austenitic Stainless Steel

C585-22

Standard Practice for Inner and Outer Diameters of Thermal Insulation for Nominal Sizes of Pipe and Tubing