ASTM C563-02 - 10.6.2002
 
1. Scope

1.1 This test method describes the determination of optimum SO3 for maximum 24-h compressive strength by measuring the change in strength produced in hydraulic cement mortar as a result of substituting calcium sulfate for a portion of the cement. Usually, but not always, the SO3 content that produces the highest 24-h strength at 23°C also produces approximately the lowest expansion in water and the lowest contraction in air at that temperature.

1.2 This test method refers to the sulfur trioxide (SO3) content of the cement only. Slag cements and occasionally other hydraulic cements can contain sulfide or other forms of sulfur. The determination of SO3 content by rapid methods may include these other forms, and may therefore produce a significant error. If a significant error occurs, analyze the cement for SO3 content using the reference test method of Test Methods C 114 for sulfur trioxide.

1.3 Values stated as SI units are to be regarded as standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

C471M-25

Standard Test Methods for Chemical Analysis of Gypsum and Gypsum Products (Metric)

C511-21

Standard Specification for Mixing Rooms, Moist Cabinets, Moist Rooms, and Water Storage Tanks Used in the Testing of Hydraulic Cements and Concretes

C150-07

Standard Specification for Portland Cement

C595-08

Standard Specification for Blended Hydraulic Cements

C1157-08

Standard Performance Specification for Hydraulic Cement

C1437-26

Standard Test Method for Flow of Hydraulic Cement Mortar

C109/C109M-26a

Standard Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 50 mm [2 in.] Cube Specimens) (Includes all amendments and changes 7/30/2026).

C114-24

Standard Test Methods for Chemical Analysis of Hydraulic Cement

C204-26

Standard Test Methods for Fineness of Hydraulic Cement by Air-Permeability Apparatus

C305-20

Standard Practice for Mechanical Mixing of Hydraulic Cement Pastes and Mortars of Plastic Consistency