ASTM C610-09e1 - 1.5.2009
 
1. Scope

1.1 This specification covers molded expanded perlite block, fittings, and pipe thermal insulation intended for use on surfaces with temperatures between 80 to 1200°F (27 to 649°C).

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 When the installation or use of thermal insulation materials, accessories, and systems may pose safety or health problems, the manufacturer shall provide the user appropriate current information regarding any known problems associated with the recommended use of the company's products and shall also recommend protective measures to be employed in their safe utilization. The following safety caveat applies only to the test methods portion of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

C177-19(2026)

Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus

E84-26a

Standard Test Method for Surface Burning Characteristics of Building Materials (Includes all amendments and changes 4/15/2026).

C302-13(2022)

Standard Test Method for Density and Dimensions of Preformed Pipe-Covering-Type Thermal Insulation

C303-21

Standard Test Method for Dimensions and Density of Preformed Block and Board–Type Thermal Insulation

C335/C335M-23

Standard Test Method for Steady-State Heat Transfer Properties of Pipe Insulation

C356-22

Standard Test Method for Linear Shrinkage of Preformed High-Temperature Thermal Insulation Subjected to Soaking Heat

C390-08(2024)

Standard Practice for Sampling and Acceptance of Thermal Insulation Lots

C411-26

Standard Test Method for Hot-Surface Performance of High-Temperature Thermal Insulation

C421-26

Standard Test Method for Tumbling Friability of Preformed Block-Type and Preformed Pipe-Covering-Type Thermal Insulation

C165-23

Standard Test Method for Measuring Compressive Properties of Thermal Insulations

C168-25

Standard Terminology Relating to Thermal Insulation

C585-22

Standard Practice for Inner and Outer Diameters of Thermal Insulation for Nominal Sizes of Pipe and Tubing

C795-08(2023)

Standard Specification for Thermal Insulation for Use in Contact with Austenitic Stainless Steel

C450-18(2026)

Standard Practice for Fabrication of Thermal Insulating Fitting Covers for NPS Piping, and Vessel Lagging

E136-26

Standard Test Method for Assessing Combustibility of Materials Using a Vertical Tube Furnace at 750 °C

C518-21

Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus

C1045-19(2026)

Standard Practice for Calculating Thermal Transmission Properties Under Steady-State Conditions

C1058/C1058M-10(2023)

Standard Practice for Selecting Temperatures for Evaluating and Reporting Thermal Properties of Thermal Insulation

C1616-25

Standard Test Method for Determining the Moisture Content of Organic and Inorganic Insulation Materials by Weight

C1617-24

Standard Test Method for Quantitative Accelerated Laboratory Evaluation of Extraction Solutions Containing Ions Leached from Thermal Insulation on Aqueous Corrosion of Carbon Steel

C1763-20(2025)

Standard Test Method for Water Absorption by Immersion of Thermal Insulation Materials

C203-22

Standard Test Methods for Breaking Load and Flexural Properties of Block-Type Thermal Insulation