ASTM C617-09 - 1.5.2009
 
Significance and Use

This practice describes procedures for providing plane surfaces on the ends of freshly molded concrete cylinders, hardened cylinders, or drilled concrete cores when the end surfaces do not conform with the planeness and perpendicularity requirements of applicable standards. Practice C 1231/C 1231M describes alternative procedures using unbonded caps or pad caps.

 
1. Scope

1.1 This practice covers apparatus, materials, and procedures for capping freshly molded concrete cylinders with neat cement and hardened cylinders and drilled concrete cores with high-strength gypsum plaster or sulfur mortar.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precaution statements see 4.3.1 and 6.2.4.1.

 
2. Referenced Documents

B46.1

Standard for Surface Texture (Surface, Roughness, Waviness and Lay)

C1231/C1231M-23

Standard Practice for Use of Unbonded Caps in Determination of Compressive Strength of Hardened Cylindrical Concrete Specimens

C595-08

Standard Specification for Blended Hydraulic Cements

C109/C109M-26a

Standard Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 50 mm [2 in.] Cube Specimens) (Includes all amendments and changes 7/30/2026).

C150-07

Standard Specification for Portland Cement

C472-26

Standard Test Methods for Physical Testing of Gypsum, Gypsum Plasters, and Gypsum Concrete