ASTM C645-18 - 1.6.2018
 
1. Scope

1.1 This specification covers nonstructural steel framing members in interior construction assemblies.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following safety hazards caveat pertains only to the test methods portion, Sections 9 and 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

S220

A653/A653M-25a

Standard Specification for Steel Sheet, Zinc-Coated (Galvanized) or Zinc-Iron Alloy-Coated (Galvannealed) by the Hot-Dip Process (Includes all amendments and changes 12/5/2025).

A1003/A1003M-26

Standard Specification for Steel Sheet, Carbon, Metallic- and Nonmetallic-Coated for Cold-Formed Framing Members

S100

North American Specification for the Design of Cold-Formed Steel Structural Members, 2007 edition

C1396/C1396M-24

Standard Specification for Gypsum Board

C1002-22

Standard Specification for Steel Self-Piercing Tapping Screws for Application of Gypsum Panel Products or Metal Plaster Bases to Wood Studs or Steel Studs

C754-20

Standard Specification for Installation of Steel Framing Members to Receive Screw-Attached Gypsum Panel Products

ICC-ES-AC86

Acceptance Criteria for Cold-formed Steel Framing Members--Interior Nonload-bearing Wall Assemblies--Approved May 2012

C11-25

Standard Terminology Relating to Gypsum and Related Building Materials and Systems

C475/C475M-17(2022)

Standard Specification for Joint Compound and Joint Tape for Finishing Gypsum Board