ASTM C658-98 - 10.9.1998
 
1. Scope

1.1 This specification covers the requirements for chemical-resistant resin grouts for filling joints of chemical-resistant brick or tile units. (For mortars, see Specification C395.)

1.2 The values stated in inch-pound units are to be regarded as the standard. The metric equivalents of inch-pound units may be approximate.

Note-Resin tile grouts are applied to joints, generally 1/4 in. (6 mm) wide, after the chemical-resistant brick or tile units are set in place on a horizontal substrate (grouting or tilesetters method). Resin mortars are trowelled on the sides and bottom of brick or tile units, generally 1/8 in. (3 mm) in thickness, before the brick or tile units are laid in place (buttering or brick-layers method). Refer to Specification C395.
 
2. Referenced Documents

C579-23

Standard Test Methods for Compressive Strength of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes

C904-25

Standard Terminology Relating to Chemical-Resistant Nonmetallic Materials

C307-23

Standard Test Method for Tensile Strength of Chemical-Resistant Mortar, Grouts, and Monolithic Surfacings

C723-98

Standard Practice for Chemical-Resistant Resin Grouts for Brick or Tile

C531-18(2023)

Standard Test Method for Linear Shrinkage and Coefficient of Thermal Expansion of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes

C413-18(2023)

Standard Test Method for Absorption of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes

C308-18(2023)

Standard Practice for Working, Initial Setting, and Service Strength Setting Times of Chemical-Resistant Resin Mortars

C395-24

Standard Specification for Chemical-Resistant Resin Mortars