ASTM C668-98(2003)e1 - 10.1.2003
 
1. Scope

1.1 This specification covers asbestos-cement transmission pipe intended for use in transmission systems that carry fluids under pressure. A transmission system consists of pipe lines which convey fluids from their source to a point of distribution or discharge. The system is characterized by relatively steady flow and few appurtenances, thereby permitting reasonable hydraulic analysis, including surge analysis.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

Note 1—This specification is issued for product standardization and purchasing purposes only, and does not include requirements for installation or the relationships between operating conditions and the strength characteristics of the various classifications of pipe. The purchaser is cautioned that he must correlate installation and operating conditions with the specified characteristics of the pipe.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 10.1 for a specific hazards statement.

 
2. Referenced Documents

D2946-01

Standard Terminology for Asbestos and Asbestos-Cement Products

Uniform Freight Classification

Rules Available from the Uniform Classification Commission, Room 1106, 222 S. Riverside Plaza, Chicago, IL?60606.

National Motor Freight Classification

Rules Available from National Motor Freight Inc., 1616 P St., NW, Washington, DC?20036.

Fed. Std. No. 123

Marking for Shipment (Civil Agencies) Available from Standardization Documents Order Desk, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094 Attn: NPODS.

MIL-STD-129

Marking for Shipment and Storage

D1869-15(2022)

Standard Specification for Rubber Rings for Fiber-Reinforced Cement Pipe

C595-08

Standard Specification for Blended Hydraulic Cements

C500-07

Standard Test Methods for Asbestos-Cement Pipe

C150-07

Standard Specification for Portland Cement

C458-98

Standard Test Method for Organic Fiber Content of Asbestos-Cement Products

C618-26

Standard Specification for Coal Ash and Raw or Calcined Natural Pozzolan for Use in Concrete