ASTM C722-94 - 1.1.1993
 
1. Scope

1.1 This specification covers the requirements for filled resin-based systems suitable for use as trowel- or spray-applied monolithic surfacings in areas where chemical resistance is required. Two types are covered:

1.1.1 Type A -Surfacings where chemical resistance and resistance to moderate to heavy traffic are required.

1.1.2 Type B -Surfacings where mild chemical resistance and severe thermal shock stability (or resistance) are required.

1.2 Seamless decorative flooring materials and monolithic surfacings utilized as vessel linings are excluded from this specification.

1.3 The following precautionary caveat pertains only to the test methods portion, Section 7, of this standard. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

D2047-25

Standard Test Method for Static Coefficient of Friction of Polish-Coated Flooring Surfaces as Measured by the James Machine

D6132-13(2022)

Standard Test Method for Nondestructive Measurement of Dry Film Thickness of Applied Organic Coatings Using an Ultrasonic Coating Thickness Gage

ESD-S7.1

ESD Association Standard for Protection of Electrostatic Discharge Susceptible Items--Floor Materials--Resistive Characterization of Materials

C307-23

Standard Test Method for Tensile Strength of Chemical-Resistant Mortar, Grouts, and Monolithic Surfacings

D1308-20(2025)

Standard Test Method for Effect of Household Chemicals on Clear and Pigmented Coating Systems

D790-25

Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials

D638-22

Standard Test Method for Tensile Properties of Plastics

C1486-18(2023)

Standard Practice for Testing Chemical-Resistant Broadcast and Slurry-Broadcast Resin Monolithic Floor Surfacings

C1028-07

Standard Test Method for Determining the Static Coefficient of Friction of Ceramic Tile and Other Like Surfaces by the Horizontal Dynamometer Pull-Meter Method

C904-25

Standard Terminology Relating to Chemical-Resistant Nonmetallic Materials

C811-98

Standard Practice for Surface Preparation of Concrete for Application of Chemical-Resistant Resin Monolithic Surfacings

C580-18(2023)

Standard Test Method for Flexural Strength and Modulus of Elasticity of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes

C267-20(2026)

Standard Test Methods for Chemical Resistance of Mortars, Grouts, and Monolithic Surfacings and Polymer Concretes

C413-18(2023)

Standard Test Method for Absorption of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes

C531-18(2023)

Standard Test Method for Linear Shrinkage and Coefficient of Thermal Expansion of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes

C579-23

Standard Test Methods for Compressive Strength of Chemical-Resistant Mortars, Grouts, Monolithic Surfacings, and Polymer Concretes