ASTM C726-17 - 1.3.2017
 
1. Scope

1.1 This specification covers the composition and physical properties of mineral wool insulation board used above structural roof decks in building construction. The mineral wool roof insulation acts as a base for systems such as single-ply, polymer-modified bitumen and built-up roof. This specification also covers mineral wool insulation boards that incorporate a fibrous high density upper layer on the top surface

1.2 It is possible that the use of thermal insulation materials covered by this specification will be regulated by building codes or other agencies that address fire performance, or both. The fire performance of the material needs to be addressed through standard fire test methods established by the appropriate governing documents.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of the regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

C390-08(2024)

Standard Practice for Sampling and Acceptance of Thermal Insulation Lots

C303-21

Standard Test Method for Dimensions and Density of Preformed Block and Board–Type Thermal Insulation

C203-22

Standard Test Methods for Breaking Load and Flexural Properties of Block-Type Thermal Insulation

C177-19(2026)

Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus

C168-25

Standard Terminology Relating to Thermal Insulation

C165-23

Standard Test Method for Measuring Compressive Properties of Thermal Insulations

C209-20(2026)

Standard Test Methods for Cellulosic Fiber Insulating Board

ISO 1716

:2002, Reaction-to-Fire Tests for Building Products Determination of the Heat of Combustion Available from International Organization for Standardization (ISO), 1, ch. de la Voie-Creuse, CP 56, CH-1211 Geneva 20, Switzerland, http://www.iso.org.

E2058-26

Standard Test Methods for Measurement of Material Flammability Using a Fire Propagation Apparatus (FPA)

E84-26a

Standard Test Method for Surface Burning Characteristics of Building Materials (Includes all amendments and changes 4/15/2026).

D2126-25

Standard Test Method for Response of Rigid Cellular Plastics to Thermal and Humid Aging

D450-07

Standard Specification for Coal-Tar Pitch Used in Roofing, Dampproofing, and Waterproofing

D482-25

Standard Test Method for Ash from Petroleum Products

C665-24

Standard Specification for Mineral-Fiber Blanket Thermal Insulation for Light Frame Construction and Manufactured Housing

C518-21

Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus

D312-00

Standard Specification for Asphalt Used in Roofing

C1363-24

Standard Test Method for Thermal Performance of Building Materials and Envelope Assemblies by Means of a Hot Box Apparatus