ASTM C728-97 - 10.5.1997
 
1. Scope

1.1 This specification covers the composition and physical properties for perlite thermal insulation board used principally above structural roof decks and as a base for built-up, modified, and elastomeric membrane roofing in building construction.

1.2 The use of thermal insulation materials covered by this specification may be regulated by building codes or other agencies that address fire performance, or both. The fire performance of the material should be addressed through standard fire test methods established by the appropriate governing documents.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 The following safety hazards caveat pertains only to the test methods, Section 11, in this specification:This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

C177-19(2026)

Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus

C168-25

Standard Terminology Relating to Thermal Insulation

C203-22

Standard Test Methods for Breaking Load and Flexural Properties of Block-Type Thermal Insulation

C165-23

Standard Test Method for Measuring Compressive Properties of Thermal Insulations

C209-20(2026)

Standard Test Methods for Cellulosic Fiber Insulating Board

C1763-20(2025)

Standard Test Method for Water Absorption by Immersion of Thermal Insulation Materials

E84-26a

Standard Test Method for Surface Burning Characteristics of Building Materials (Includes all amendments and changes 4/15/2026).

C390-08(2024)

Standard Practice for Sampling and Acceptance of Thermal Insulation Lots

C518-21

Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus

C1289-26

Standard Specification for Faced Rigid Cellular Polyisocyanurate Thermal Insulation Board