4.1?This practice provides requirements for planning and conducting an interlaboratory study to obtain data to develop single-operator and multilaboratory precision statements for a test method. It includes methods to evaluate data consistency before carrying out the calculations to develop the precision statement. The procedures are compatible with those in Practice E691.

4.2?The ILS data obtained from this practice are intended for developing the precision values for writing single-operator and multilaboratory precision statements in accordance with Practice C670.

4.3?Appendix X1 provides an example to illustrate the calculations to obtain the precision values of the test method from the ILS data. This may be used to check a user-developed electronic spreadsheet for carrying out the calculations.

4.4?Appendix X2 discusses the additional calculations required for an interlaboratory study of a test method that includes making test specimens as part of the procedure. In this case, batch-to-batch variability needs to be considered.

4.5?Appendix X3 discusses the use of analysis of variance as an alternative approach to obtain the precision values from the ILS data.

1.1?This practice describes techniques for planning, conducting, and analyzing the results of an interlaboratory study (ILS) with the objective of developing the precision statement of a test method. It is designed to be used in conjunction with Practice C670. The methods used in this standard are consistent with those in Practice E691.

1.2?This practice is not intended for use in programs whose purpose is to develop a test method or to assess the relative variability of two or more test methods. Refer to Practice C1067 for procedures to evaluate the ruggedness of a test method.

1.3?The system of units for this practice has not been specified. Dimensional quantities in the practice are presented only in examples of calculations.

1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.