ASTM D4679-21 - 1.11.2021
 
1. Scope

1.1?This specification covers requirements for gloves made of rubber-like latex, whether made of natural or synthetic materials, unsupported with or without a flock lining, intended for household, beautician use, or general use.

1.2?This specification is intended to serve as a guide to permit obtaining gloves of consistent performance. The safe and proper use of gloves is excluded from the scope of this specification.

1.3?The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

D3767-03(2020)

Standard Practice for Rubber´Measurement of Dimensions

D865-11(2018)

Standard Test Method for Rubber´Deterioration by Heating in Air (Test Tube Enclosure)

D412-16(2021)

Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension

D573-04(2019)

Standard Test Method for Rubber´Deterioration in an Air Oven

D5151-19(2023)

Standard Test Method for Detection of Holes in Medical Gloves