ASTM F2882-12 - 1.10.2012
 
1. Scope

1.1 This specification covers the requirements for quenched and tempered alloy steel screws 0.060 through 11/2 inches in diameter having a minimum ultimate tensile strength of 170 KSI.

Note 1—This specification is the inch companion of Specification F2882M.

1.2 The following hazard caveat pertains only to the test method portion, Section 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

A751-21

Standard Test Methods and Practices for Chemical Analysis of Steel Products

E112-13(2021)

Standard Test Methods for Determining Average Grain Size

F606-14

Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

F788/F788M-20e1

Standard Specification for Surface Discontinuities of Bolts, Screws, Studs, and Rivets, Inch and Metric Series (Includes all amendments and changes 9/12/2023).

F1470-24

Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

F1940-07a(2019)

Standard Test Method for Process Control Verification to Prevent Hydrogen Embrittlement in Plated or Coated Fasteners (Includes all amendments and changes 9/17/2019).

F2282-23

Standard Specification for Quality Assurance Requirements for Carbon and Alloy Steel Wire, Rods, and Bars for Mechanical Fasteners

F2328-17(2022)

Standard Test Method for Determining Decarburization and Carburization in Hardened and Tempered Threaded Steel Bolts, Screws, Studs, and Nuts

B18.24

Part Identifying Number (PIN) Code System Standard for B18 Fastener Products