ASTM F2882M-12 - 1.10.2012
 
1. Scope

1.1 This specification covers the requirements for quenched and tempered alloy steel screws 1.6 mm through 48 mm in diameter having a minimum ultimate tensile strength of 1170 MPa.

Note 1—This specification is the metric companion of Specification F2882.

1.2 The following hazard caveat pertains only to the test method portion, Section 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

F788/F788M-20e1

Standard Specification for Surface Discontinuities of Bolts, Screws, Studs, and Rivets, Inch and Metric Series (Includes all amendments and changes 9/12/2023).

F1470-24

Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

F1940-07a(2019)

Standard Test Method for Process Control Verification to Prevent Hydrogen Embrittlement in Plated or Coated Fasteners (Includes all amendments and changes 9/17/2019).

F2282-23

Standard Specification for Quality Assurance Requirements for Carbon and Alloy Steel Wire, Rods, and Bars for Mechanical Fasteners

F606M-14

Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, and Rivets (Metric) (Withdrawn 2015)

B18.24

Part Identifying Number (PIN) Code System Standard for B18 Fastener Products

A751-21

Standard Test Methods and Practices for Chemical Analysis of Steel Products

E112-13(2021)

Standard Test Methods for Determining Average Grain Size

F2328M-17(2022)

Standard Test Method for Determining Decarburization and Carburization in Hardened and Tempered Threaded Steel Bolts, Screws, Studs, and Nuts (Metric)