ASTM D7055-04 - 1.6.2004
 
1. Scope

1.1 This practice covers the procedures to be followed in the preparation (by abrasive blast cleaning) of hot rolled steel panels for laboratory testing of coatings.

1.2 This standard practice does not include procedures for the application of coatings.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

A572/A572M-25

Standard Specification for High-Strength Low-Alloy Columbium-Vanadium Structural Steel

SP 10/NACE No. 2

Near-White Metal Blast Cleaning

SP 6/NACE No. 3

Commercial Blast Cleaning

SP 5/NACE No. 1

White Metal Blast Cleaning

SP 1

Solvent Cleaning

AB-3

Newly Manufactured or Re-Manufactured Steel Abrasives

AB-2

Specification for Cleanliness of Recycled Ferrous Metallic Abrasives

AB-1

Mineral and Slag Abrasives

ISO 8502-3, Part 3

Assessment of Dust on Steel Surfaces Prepared for Painting (pressure-sensitive tape method) Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.

D7393-25

Standard Practice for Indicating Oil in Abrasives

D4940-25

Standard Test Method for Conductimetric Analysis of Water Soluble Ionic Contamination of Blast Cleaning Abrasives

D4417-21

Standard Test Methods for Field Measurement of Surface Profile of Blast Cleaned Steel

D4285-24

Standard Practice for Indicating Oil or Water in Compressed Air

SSPC-VIS 1

Guide and Reference Photographs for Steel Surfaces Prepared by Dry Abrasive Blast Cleaning

A36/A36M-19

Standard Specification for Carbon Structural Steel

A1011/A1011M-25

Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High-Strength