ASTM D8074-19 - 1.11.2019
 
Significance and Use

5.1 This test method was developed to evaluate the liner scuffing and ring distress performance of engine oils in turbocharged and intercooled four-cycle diesel engines equipped with EGR, uncoated top rings, and running on ultra-low sulfur diesel fuel. Results are obtained from used oil analysis, operational data, and component measurements before and after test.

5.2 The test method may be used for engine oil specification acceptance when all details of the procedure are followed.

 
1. Scope

1.1 This test method covers an engine test procedure for evaluating diesel engine oils for performance characteristics, including adhesive wear between an uncoated piston ring and cylinder liner. This test method is commonly referred to as the DD13 Scuffing Test.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1 Exception—Where there is no direct SI equivalent, such as the units for screw threads, National Pipe Threads/diameters, tubing size, and single source supply equipment specifications.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See Annex A2 for specific safety precautions.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

D97-17b(2022)

Standard Test Method for Pour Point of Petroleum Products (Includes all amendments and changes 11/29/2022).

D130-26

Standard Test Method for Corrosiveness to Copper from Petroleum Products by Copper Strip Test

D235-22

Standard Specification for Mineral Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent)

D287-22

Standard Test Method for API Gravity of Crude Petroleum and Petroleum Products (Hydrometer/Method)

D445-24

Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)

D482-25

Standard Test Method for Ash from Petroleum Products

D524-15(2025)e1

Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products (Includes all amendments and changes 8/11/2025).

D613-25a

Standard Test Method for Cetane Number of Diesel Fuel Oil (Includes all amendments and changes 11/6/2025).

D664-24

Standard Test Method for Acid Number of Petroleum Products by Potentiometric Titration

D975-26b

Standard Specification for Diesel Fuel (Includes all amendments and changes 3/31/2026).

D976-21e1

Standard Test Method for Calculated Cetane Index of Distillate Fuels (Includes all amendments and changes 2/23/2023).

D1319-25

Standard Test Method for Hydrocarbon Types in Liquid Petroleum Products by Fluorescent Indicator Adsorption

D2274-14(2019)

Standard Test Method for Oxidation Stability of Distillate Fuel Oil (Accelerated Method)

D2500-23

Standard Test Method for Cloud Point of Petroleum Products and Liquid Fuels

D6984-18e1

Standard Test Method for Evaluation of Automotive Engine Oils in the Sequence IIIF, Spark-Ignition Engine (Includes all amendments and changes 6/23/2022).

D7320-18e1

Standard Test Method for Evaluation of Automotive Engine Oils in the Sequence IIIG, Spark-Ignition Engine (Includes all amendments and changes 6/23/2022).

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E168-16(2023)

Standard Practices for General Techniques of Infrared Quantitative Analysis

Code of Federal Regulations

Title 40 Part 86.310-79, Available from U.S. Government Printing Office, Superintendent of Documents, 732 N. Capitol St., NW, Washington, DC 20401-0001, http://www.access.gpo.gov. https://www.gpo.gov/fdsys/granule/CFR-2013-title40-vol19/CFR-2013-title40-vol19-sec86-310-79.

ASTM Deposit Rating Manual 20

D86-23ae2

Standard Test Method for Distillation of Petroleum Products and Liquid Fuels at Atmospheric Pressure (Includes all amendments and changes 11/4/2024).

D93-26

Standard Test Methods for Flash Point by Pensky-Martens Closed Cup Tester

D6078-04

Standard Test Method for Evaluating Lubricity of Diesel Fuels by the Scuffing Load Ball-on-Cylinder Lubricity Evaluator (SLBOCLE)

D3524-14(2020)

Standard Test Method for Diesel Fuel Diluent in Used Diesel Engine Oils by Gas Chromatography

D4052-22

Standard Test Method for Density, Relative Density, and API Gravity of Liquids by Digital Density Meter

D4175-24e1

Standard Terminology Relating to Petroleum Products, Liquid Fuels, and Lubricants (Includes all amendments and changes 11/19/2024).

D4294-24

Standard Test Method for Sulfur in Petroleum and Petroleum Products by Energy Dispersive X-ray Fluorescence Spectrometry

D4683-25

Standard Test Method for Measuring Viscosity of New and Used Engine Oils at High Shear Rate and High Temperature by Tapered Bearing Simulator Viscometer at 150 ?C

D4739-23

Standard Test Method for Base Number Determination by Potentiometric Hydrochloric Acid Titration

D5185-26

Standard Test Method for Multielement Determination of Used and Unused Lubricating Oils and Base Oils by Inductively Coupled Plasma Atomic Emission Spectrometry (ICP-AES)

D5186-24

Standard Test Method for Determination of the Aromatic Content and Polynuclear Aromatic Content of Diesel Fuels By Supercritical Fluid Chromatography

D5453-25

Standard Test Method for Determination of Total Sulfur in Light Hydrocarbons, Spark Ignition Engine Fuel, Diesel Engine Fuel, and Engine Oil by Ultraviolet Fluorescence

D5967-21

Standard Test Method for Evaluation of Diesel Engine Oils in T-8 Diesel Engine

D2622-26

Standard Test Method for Sulfur in Petroleum Products by Wavelength Dispersive X-ray Fluorescence Spectrometry

D2709-22

Standard Test Method for Water and Sediment in Middle Distillate Fuels by Centrifuge

D3338-08

Standard Test Method for Estimation of Net Heat of Combustion of Aviation Fuels