ASTM D849-97 - 10.1.2002
 
1. Scope

1.1 This test method determines the corrosiveness of industrial aromatic hydrocarbons to a copper strip.

Note 1—For a similar copper strip test applicable to other petroleum products, see Method D 130 and Test Method D 1838.

<>

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 8.

 
2. Referenced Documents

OSHA Regulations, 29 CFR

paragraphs 1910.1000 and 1910.1200

D6809-24

Standard Guide for Quality Control and Quality Assurance Procedures for Aromatic Hydrocarbons and Related Materials

D4790-25

Standard Terminology of Aromatic Hydrocarbons and Related Chemicals

D1838-21

Standard Test Method for Copper Strip Corrosion by Liquefied Petroleum (LP) Gases

D130-26

Standard Test Method for Corrosiveness to Copper from Petroleum Products by Copper Strip Test

ASTM Copper Strip Corrosion Standards (13 photo lithographed aluminum strips; includes Test Method ) Available from ASTM International Headquarters. Request Adjunct No. . Names of suppliers in the United Kingdom can be obtained from the Energy Institute, 61 New Cavendish St., London, W1G 7AR, U.K. Two master standards are held by the EI for reference.

B152/B152M-24

Standard Specification for Copper Sheet, Strip, Plate, and Rolled Bar