ASTM D946/D946M-15 - 1.12.2015
 
1. Scope

1.1 This specification covers asphalt binder for use in the construction of pavements.

Note 1: For asphalt binders graded by viscosity at 60°C, see Specification D3381. For performance-graded asphalt binder, see Specification D6373.

1.2 This specification covers the following penetration grades:

40–50,

120–150, and

60–70,

200–300.

 85–100,

 

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

 
2. Referenced Documents

D1754-97

Standard Test Method for Effect of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)

D113-17

Standard Test Method for Ductility of Asphalt Materials

D92-24

Standard Test Method for Flash and Fire Points by Cleveland Open Cup Tester

D140-01

Standard Practice for Sampling Bituminous Materials

D7553-15(2021)

Standard Test Method for Solubility of Asphalt Materials in N-Propyl Bromide

D3381-09

Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction

D6373-23

Standard Specification for Performance-Graded Asphalt Binder

D36-06

Standard Test Method for Softening Point of Bitumen (Ring-and-Ball Apparatus)

D5-06

Standard Test Method for Penetration of Bituminous Materials

D2042-25

Standard Test Method for Solubility of Asphalt Materials