ASTM E2206-02 - 10.5.2002
 
1. Scope

1.1 This method describes the calibration or performance confirmation of the electronically applied force signal for thermomechanical analyzers over the range of 0 to 1 N.

1.2 SI units are the standard.

1.3 There is no ISO method equivalent to this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

E4-21

Standard Practices for Force Calibration and Verification of Testing Machines

E1142-23b

Standard Terminology Relating to Thermophysical Properties (Includes all amendments and changes 10/5/2023).

E831-19

Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis

E2113-23

Standard Test Method for Length Change Calibration of Thermomechanical Analyzers

E473-23b

Standard Terminology Relating to Thermal Analysis and Rheology (Includes all amendments and changes 10/5/2023).

E617-23

Standard Specification for Laboratory Weights and Precision Mass Standards

E1363-23

Standard Test Method for Temperature Calibration of Thermomechanical Analyzers

E2161-23c

Standard Terminology Relating to Performance Validation in Thermal Analysis and Rheology (Includes all amendments and changes 8/17/2023).