ASTM E2312-11 - 1.1.2011
 
Significance and Use

This practice is not intended to advocate or discourage use of any particular test method. It is intended for information only, and to provide a useful guide for further detailed study, test, and evaluation of cleanroom materials and products.

 
1. Scope

1.1 This practice identifies test methods used to evaluate the properties of various materials and products used in cleanrooms and for cleanroom construction.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

E1216-21

Standard Practice for Sampling for Particulate Contamination by Tape Lift

F51-00

Standard Test Method for Sizing and Counting Particulate Contaminant In and On Clean Room Garments

E595-15(2021)

Standard Test Method for Total Mass Loss and Collected Volatile Condensable Materials from Outgassing in a Vacuum Environment

E1559-09(2022)

Standard Test Method for Contamination Outgassing Characteristics of Spacecraft Materials

E1549-06

Standard Specification for ESD Controlled Garments Required in Cleanrooms and Controlled Environments for Spacecraft for Non-Hazardous and Hazardous Operations

E1234-12(2020)

Standard Practice for Handling, Transporting, and Installing Nonvolatile Residue (NVR) Sample Plates Used in Environmentally Controlled Areas for Spacecraft

F739-20

Standard Test Method for Permeation of Liquids and Gases Through Protective Clothing Materials Under Conditions of Continuous Contact

E1235-12(2020)e1

Standard Test Method for Gravimetric Determination of Nonvolatile Residue (NVR) in Environmentally Controlled Areas for Spacecraft (Includes all amendments and changes 6/9/2020).

F25-04

Standard Test Method for Sizing and Counting Airborne Particulate Contamination in Cleanrooms and Other Dust-Controlled Areas

E2217-12(2019)

Standard Practice for Design and Construction of Aerospace Cleanrooms and Contamination Controlled Areas

E2090-12(2020)

Standard Test Method for Size-Differentiated Counting of Particles and Fibers Released from Cleanroom Wipers Using Optical and Scanning Electron Microscopy

E2088-06(2021)

Standard Practice for Selecting, Preparing, Exposing, and Analyzing Witness Surfaces for Measuring Particle Deposition in Cleanrooms and Associated Controlled Environments

E1731-11(2018)

Standard Test Method for Gravimetric Determination of Nonvolatile Residue from Cleanroom Gloves

E1560-18

Standard Test Method for Gravimetric Determination of Nonvolatile Residue From Cleanroom Wipers