ASTM E2352-19 - 1.5.2019
 
1. Scope

1.1 This practice specifies basic requirements, procedures, and practices for operating aerospace cleanrooms and controlled environments and precautions associated with the facility and equipment used.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

E1559-09(2022)

Standard Test Method for Contamination Outgassing Characteristics of Spacecraft Materials

E1560-18

Standard Test Method for Gravimetric Determination of Nonvolatile Residue From Cleanroom Wipers

E1731-11(2018)

Standard Test Method for Gravimetric Determination of Nonvolatile Residue from Cleanroom Gloves

E1235-12(2020)e1

Standard Test Method for Gravimetric Determination of Nonvolatile Residue (NVR) in Environmentally Controlled Areas for Spacecraft (Includes all amendments and changes 6/9/2020).

E1549-06

Standard Specification for ESD Controlled Garments Required in Cleanrooms and Controlled Environments for Spacecraft for Non-Hazardous and Hazardous Operations

E2042-04

Standard Practice for Cleaning and Maintaining Controlled Areas and Clean Rooms

E1234-12(2020)

Standard Practice for Handling, Transporting, and Installing Nonvolatile Residue (NVR) Sample Plates Used in Environmentally Controlled Areas for Spacecraft

E2088-06(2021)

Standard Practice for Selecting, Preparing, Exposing, and Analyzing Witness Surfaces for Measuring Particle Deposition in Cleanrooms and Associated Controlled Environments

E2217-12(2019)

Standard Practice for Design and Construction of Aerospace Cleanrooms and Contamination Controlled Areas

F25-04

Standard Test Method for Sizing and Counting Airborne Particulate Contamination in Cleanrooms and Other Dust-Controlled Areas

F50-21

Standard Practice for Continuous Sizing and Counting of Airborne Particles in Dust-Controlled Areas and Clean Rooms Using Instruments Capable of Detecting Single Sub-Micrometre and Larger Particles

F51-00

Standard Test Method for Sizing and Counting Particulate Contaminant In and On Clean Room Garments

F318-06

Standard Practice for Sampling Airborne Particulate Contamination in Cleanrooms for Handling Aerospace Fluids

NASA-STD-6001, Test #7

Flammability, Odor, Offgassing and Compatibility Requirements and Test Procedures for Materials in Environments That Support Combustion

D737-18(2023)

Standard Test Method for Air Permeability of Textile Fabrics

E595-15(2021)

Standard Test Method for Total Mass Loss and Collected Volatile Condensable Materials from Outgassing in a Vacuum Environment

E1216-21

Standard Practice for Sampling for Particulate Contamination by Tape Lift