ASTM E272-99 - 10.12.1999
 
1. Scope

1.1 These reference radiographs illustrate various types and degrees of discontinuities occurring in high-strength copper-base, nickel-copper, and related types of alloys.

1.2 These reference radiographs are reproductions of original radiographs that contain indications of discontinuities in sand-cast manganese-nickel-aluminum bronze-alloy plates. These discontinuities are representative of those found in high-shrinkage, high-strength copper and nickel-copper alloys.

1.3 The values stated in inch-pound units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

B369-09

Standard Specification for Copper-Nickel Alloy Castings

E446-20

Standard Reference Radiographs for Steel Castings Up to 2 in. (50.8 mm) in Thickness

E94-04

Standard Guide for Radiographic Examination

E186-20

Standard Reference Radiographs for Heavy-Walled (2 to 412 in. (50.8 to 114 mm)) Steel Castings

B584-22

Standard Specification for Copper Alloy Sand Castings for General Applications

E1316-24

Standard Terminology for Nondestructive Examinations

E242-15(2020)

Standard Reference Radiographs for Appearances of Radiographic Images as Certain Parameters are Changed

E192-20

Standard Reference Radiographs of Investment Steel Castings for Aerospace Applications

MIL-B-21230A

Bronze, Nickel Aluminum and Manganese-Nickel Aluminum, Casting, Ship Propeller Application Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098

Reference Radiographs for High-Strength Copper-Base and Nickel-Copper Alloy Castings Available from ASTM Headquarters. Order .

B148-18

Standard Specification for Aluminum-Bronze Sand Castings