ASTM E517-00(2006)

ASTM E517-00(2006) - 1.9.2006

1. Scope

1.1 This test method covers special tension testing for the measurement of the plastic strain ratio, r, of sheet metal intended for deep-drawing applications.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents

E83-23	Standard Practice for Verification and Classification of Extensometer Systems
E8-04	Standard Test Methods for Tension Testing of Metallic Materials
E6-23a	Standard Terminology Relating to Methods of Mechanical Testing (Includes all amendments and changes 3/29/2023).
E691-23	Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
E177-20	Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E92-23	Standard Test Methods for Vickers Hardness and Knoop Hardness of Metallic Materials