1.1 This specification covers expanded metal. 1.1.1 Expanded metal covered by this specification is intended for a variety of applications. 1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only and may be approximate. 1.3 The following precautionary caveat pertains only to the test methods portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
A1011/A1011M-23 | Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength |
SAE J?1086 | Metals and Alloys in the Unified Numbering System |
MIL-C-16173 | Corrosion Preventive Compound, Solvent Cutback, Cold-Application |
MIL-STD-105 | Sampling Procedures and Tables for Inspection by Attributes |
A1008/A1008M-23e1 | Standard Specification for Steel, Sheet, Cold-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, Required Hardness, Solution Hardened, and Bake Hardenable (Includes all amendments and changes 12/29/2023). |
A123/A123M-17 | Standard Specification for Zinc (Hot-Dip Galvanized) Coatings on Iron and Steel Products |
A240/A240M-23a | Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications (Includes all amendments and changes 11/7/2023). |
A653/A653M-23 | Standard Specification for Steel Sheet, Zinc-Coated (Galvanized) or Zinc-Iron Alloy-Coated (Galvannealed) by the Hot-Dip Process |
A666-23 | Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar |
A700-14(2019) | Standard Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment |
|