ASTM F1869-03 - 1.11.2003
 
1. Scope

1.1 This test method covers the quantitative determination of the rate of moisture vapor emitted from below-grade, on-grade, and above-grade (suspended) concrete floors.

1.2 This quantity of moisture shall be expressed as the rate of moisture vapor emission, measured in pounds of moisture over a 1000 ft2 area during a 24-h period.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

ICRI Technical Guideline 310.1-1997

Selecting and Specifying Concrete Surface Preparation for Sealers, Coatings, and Polymer Overlays

E1745-17(2023)

Standard Specification for Plastic Water Vapor Retarders Used in Contact with Soil or Granular Fill under Concrete Slabs

E1993-98

Standard Specification for Bituminous Water Vapor Retarders Used in Contact with Soil or Granular Fill Under Concrete Slabs

F141-23

Standard Terminology Relating to Resilient Floor Coverings

MIL-PRF-131

Recommended Work Practices