ASTM F1909-98 - 10.7.1998
 
1. Scope

1.1 This specification covers preformed open-cell sponge rubber gaskets of the following classes for use in new or reconditioned pails or drums.

1.1.1 Class A - Non-Oil Resistant.

1.1.2 Class B - Oil Resistant

1.2 the values stated in SI units are to be regarded as the standard.

1.3 The following safety hazards caveat pertains only to the test methods sections of the specification. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

D575-91(2018)

Standard Test Methods for Rubber Properties in Compression

D573-04(2019)

Standard Test Method for Rubber´Deterioration in an Air Oven

D395-18

Standard Test Methods for Rubber Property´Compression Set

D3183-10(2019)

Standard Practice for Rubber´Preparation of Pieces for Test Purposes from Products

D3182-21a

Standard Practice for Rubber—Materials, Equipment, and Procedures for Mixing Standard Compounds and Preparing Standard Vulcanized Sheets (Includes all amendments and changes 11/12/2021).

D1056-20

Standard Specification for Flexible Cellular Materials´Sponge or Expanded Rubber

D471-16a(2021)

Standard Test Method for Rubber Property—Effect of Liquids (Includes all amendments and changes 6/25/2021).