ASTM F2034-03 - 10.9.2003
 
1. Scope

1.1 This specification covers sheet linoleum floor covering.

1.2 Three types of linoleum floor covering are covered (see Section 4). These floor coverings are intended for use in commercial, light commercial, and residential buildings based on serviceability characteristics. General information and performance characteristics, which determine serviceability and recommended use, are included in this specification.

1.3 The values stated in inch-pound units are to be regarded as the standard; the values in parentheses are provided for information only.

1.4 The following safety hazards caveat pertains only to the test methods portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

F386-17(2022)

Standard Test Method for Thickness of Resilient Flooring Materials Having Flat Surfaces

F410-08(2022)

Standard Test Method for Wear Layer Thickness of Resilient Floor Coverings by Optical Measurement

F710-22

Standard Practice for Preparing Concrete Floors to Receive Resilient Flooring

F925-13(2020)

Standard Test Method for Resistance to Chemicals of Resilient Flooring

F970-22

Standard Test Method for Measuring Recovery Properties of Floor Coverings after Static Loading

F1482-21

Standard Practice for Installation and Preparation of Panel Type Underlayments to Receive Resilient Flooring

F1514-19

Standard Test Method for Measuring Heat Stability of Resilient Flooring by Color Change

F1515-21

Standard Test Method for Measuring Light Stability of Resilient Flooring by Color Change

F150-06(2018)

Standard Test Method for Electrical Resistance of Conductive and Static Dissipative Resilient Flooring

F141-23

Standard Terminology Relating to Resilient Floor Coverings

F137-08(2018)

Standard Test Method for Flexibility of Resilient Flooring Materials with Cylindrical Mandrel Apparatus

ANSI/ASQC Z1.4

Sampling Procedures and Tables for Inspection by Attributes Available from American National Standards Institute, 11 West 42 nd St., 13th Floor, New York, NY 10036.

EN 670

Identification and Composition of Linoleum--Determination of Cement and Ash Residue Available from CEN European Committee for Standardization--Central Secretariat: rue de Stassart, 36 B-1050, Brussels.

F1516-23

Standard Practice for Sealing Seams of Resilient Flooring Products by the Heat Weld Method (when Recommended)