1.1 This specification covers inner rings for needle roller bearings with drawn outer rings. 1.2 The inner rings specified in this specification are intended for use on unhardened shafts in conjunction with open end needle roller bearings shown on Specification F 2162 and MS52141. 1.3 The use of recycled materials that meet the requirements of the applicable material specification without jeopardizing the intended use of the item is encouraged. 1.4 The inner rings specified in this specification are not intended for use in flight-critical systems of aircraft. 1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only. Note 1—This specification was originally developed by the Department of Defense and maintained by the Defense Supply Center Richmond. It is intended to replicate the requirements of MS 17130. |
MIL-STD-130 | Identification Marking of US Military Property Available from USA Information Systems, 1092 Laskin Rd., Ste. 208, Virginia Beach, VA 23451. |
E18-22 | Standard Test Methods for Rockwell Hardness of Metallic Materials |
ASME B 46.1 | Surface Texture Surface Roughness, Waviness, and Lay Available from Global Engineering Documents, 15 Inverness Way, East Englewood, CO 80112-5704, http://www.global.ihs.com. |
STD 4 | Tolerance Definitions and Gauging Practices For Ball and Roller Bearings Available from the American Bearing Manufacturers Association, 1200 19th St. NW, Ste. 300, Washington, DC 200362401. |
ISO 5593 | Rolling BearingsVocabulary Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org. |
MS52141 | Bearing, Roller, Needle: Drawn Outer Ring, Caged, Without Inner Ring, Open and Closed End, Standard Type |
SAE J-404 | |
SAE AHS | |
F2162-01(2016) | Standard Specification for Bearing, Roller, Needle: Drawn Outer Ring, Full Complement, Without Inner Ring, Open and Closed End, Standard Type |
|