ASTM F2329-05 - 1.2.2005
 
1. Scope

1.1 This specification covers the requirements for hot-dip zinc coating applied to carbon steel and alloy steel bolts, screws, washers, nuts, and special threaded fasteners applied by the hot-dip coating process. Nails and rivets are not included in this specification.

1.2 It is intended to be applicable to fasteners that are centrifuged or otherwise handled to remove excess galvanizing bath metal (free zinc).

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

A563-15

Standard Specification for Carbon and Alloy Steel Nuts

A153/A153M-23

Standard Specification for Zinc Coating (Hot-Dip) on Iron and Steel Hardware

E376-19

Standard Practice for Measuring Coating Thickness by Magnetic-Field or Eddy Current (Electromagnetic) Testing Methods

F1789-23

Standard Terminology for F16 Mechanical Fasteners

B487-20

Standard Test Method for Measurement of Metal and Oxide Coating Thickness by Microscopical Examination of Cross Section

F606M-14

Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, and Rivets (Metric) (Withdrawn 2015)

F606-14

Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

A563M-07

Standard Specification for Carbon and Alloy Steel Nuts [Metric]

A780-01

Standard Practice for Repair of Damaged and Uncoated Areas of Hot-Dip Galvanized Coatings

F1470-24

Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection