1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, impact resistance, pipe stiffness, flattening, buckling, tensile strength of seam, joint systems, perforations, and markings for steel reinforced thermoplastic pipe and fittings of nominal sizes 8 in. [200 mm] through 120 in. [3000 mm]. The steel reinforced, spirally formed thermoplastic pipes governed by this standard are intended for use in underground applications where soil provides support for their flexible walls. These pipes will be used for gravity flow and non-pressure applications, such as storm sewers, sanitary sewers, industrial waste applications and drainage pipes. 1.2 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text the SI units are shown in brackets. The values stated in each system may not be exact equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 There is no similar or equivalent ISO standard. |
AASHTO M294-05 | Corrugated Polyethylene Pipe, 300- to 1500-mm Diameter |
D638-22 | Standard Test Method for Tensile Properties of Plastics |
Fed. Std. No. 123 | Marking for Shipment (Civil Agencies) |
AASHTO LRFD | Bridge Construction Specification Section 26 |
D2444-21 | Standard Practice for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight) |
D3212-21 | Standard Specification for Joints for Drain and Sewer Plastic Pipes Using Flexible Elastomeric Seals |
D2412-21 | Standard Test Method for Determination of External Loading Characteristics of Plastic Pipe by Parallel-Plate Loading |
D3350-21 | Standard Specification for Polyethylene Plastics Pipe and Fittings Materials |
F412-23 | Standard Terminology Relating to Plastic Piping Systems |
F477-14(2021) | Standard Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe |
F2136-18(2024) | Standard Test Method for Notched, Constant Ligament-Stress (NCLS) Test to Determine Slow-Crack-Growth Resistance of HDPE Resins or HDPE Corrugated Pipe |
A1008/A1008M-23e1 | Standard Specification for Steel, Sheet, Cold-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, Required Hardness, Solution Hardened, and Bake Hardenable (Includes all amendments and changes 12/29/2023). |
A1011/A1011M-23 | Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength |
D618-21 | Standard Practice for Conditioning Plastics for Testing |
D2122-22 | Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings |
D2321-20 | Standard Practice for Underground Installation of Thermoplastic Pipe for Sewers and Other Gravity-Flow Applications |
MIL-STD-129 | |
|