ASTM F680-80(2002) - 26.9.1980
 
Significance and Use

When specified, the tests selected for application shall be performed to assure conformance with requirements stipulated in the product specification.

 
1. Scope

1.1 These test methods cover procedures for the testing of nails. The test or tests selected, and the requirements for compliance, will be as specified in the applicable product standard. Performance tests for nail withdrawal and lateral load capability are not included as they are covered by Test Methods D 1761.

1.2 The tests described are as follows:

Section
Dimensional tests5
Tension test6
Conventional bend test7
Impact bend test8
Rockwell hardness test9
Coating weight test10
Coating adherence test for zinc-coated nails11

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are provided for information purposes only.

 
2. Referenced Documents

A90/A90M-21

Standard Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings

D1761-20

Standard Test Methods for Mechanical Fasteners in Wood and Wood-Based Materials

E18-22

Standard Test Methods for Rockwell Hardness of Metallic Materials

A428/A428M-21

Standard Test Method for Weight [Mass] of Coating on Aluminum-Coated Iron or Steel Articles

A370-23

Standard Test Methods and Definitions for Mechanical Testing of Steel Products

F592-84(2001)

Standard Terminology of Collated and Cohered Fasteners and Their Application Tools

F547-22

Standard Terminology of Nails for Use with Wood and Wood-Base Materials