ASTM F735-17 - 1.6.2017
 
Significance and Use

4.1 Plastic materials, when used as transparencies, covers, or enclosures, are subject to wiping, cleaning, or other types of rubbing actions that cause abrasion. It is the intent of this test method to provide a means of estimating the resistance of such materials to this type and degree of abrasion.

 
1. Scope

1.1 This test method determines the resistance of transparent plastics and transparent coatings utilized in windows or viewing ports, to surface abrasion using oscillating sand.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1 Exception—The inch-pound units in parentheses are provided for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

D1003-21

Standard Test Method for Haze and Luminous Transmittance of Transparent Plastics

D618-21

Standard Practice for Conditioning Plastics for Testing

E11-22

Standard Specification for Woven Wire Test Sieve Cloth and Test Sieves

C136-06

Standard Test Method for Sieve Analysis of Fine and Coarse Aggregates