ASTM F880-02(2008) - 1.5.2008
 
1. Scope

1.1 This specification covers the requirements for austenitic grade stainless steel socket-set screws (SSS) sizes 0.060 through 0.500 in., in two conditions, AF and CW.

1.2 Units—The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1—A complete metric companion to Specification F 880 has been developed—F 880M; therefore, no metric equivalents are shown in this specification.

1.3 The following hazards caveat pertains only to Test Method Section, Section 12 of this specification. This standard does not purport to address (all of) the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

A380-06

Standard Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems

A342/A342M-21

Standard Test Methods for Permeability of Weakly Magnetic Materials

F593-22

Standard Specification for Stainless Steel Bolts, Hex Cap Screws, and Studs

F788/F788M-20e1

Standard Specification for Surface Discontinuities of Bolts, Screws, Studs, and Rivets, Inch and Metric Series (Includes all amendments and changes 9/12/2023).

A262-15(2021)

Standard Practices for Detecting Susceptibility to Intergranular Attack in Austenitic Stainless Steels

B 18.6.2

Slotted Head Cap Screws, Square Head Set Screws, and Slotted Headless Set Screws (Inch Series)

F1470-24

Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

D3951-18(2023)

Standard Practice for Commercial Packaging

A555/A555M-23

Standard Specification for General Requirements for Stainless Steel Wire and Wire Rods

E18-22

Standard Test Methods for Rockwell Hardness of Metallic Materials

A967-05

Standard Specification for Chemical Passivation Treatments for Stainless Steel Parts

A751-21

Standard Test Methods and Practices for Chemical Analysis of Steel Products