ASTM F880M-16

ASTM F880M-16 - 1.5.2016

1. Scope

1.1 This specification covers the requirements for austenitic grade stainless steel socket set screws (SSS), sizes M1.6 through M24, having Property Classes A1-50 and A1-70.

1.2 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1: This specification is the metric companion of Specification F880.

1.3 The following hazard caveat pertains only to Section 11, the Test Method Section: This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents

ISO 4029	Hexagon socket set screws with cup point
F880-12(2017)	Standard Specification for Stainless Steel Socket, Square Head, and Slotted Headless-Set Screws
F1470-24	Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection
ISO 4028
E3-11(2017)	Standard Guide for Preparation of Metallographic Specimens
D3951-18(2023)	Standard Practice for Commercial Packaging
A967/A967M-17	Standard Specification for Chemical Passivation Treatments for Stainless Steel Parts
A751-21	Standard Test Methods and Practices for Chemical Analysis of Steel Products
A555/A555M-23	Standard Specification for General Requirements for Stainless Steel Wire and Wire Rods
A380/A380M-17	Standard Practice for Cleaning, Descaling, and Passivation of Stainless Steel Parts, Equipment, and Systems
A342/A342M-21	Standard Test Methods for Permeability of Weakly Magnetic Materials
A262-15(2021)	Standard Practices for Detecting Susceptibility to Intergranular Attack in Austenitic Stainless Steels
F788-20	Standard Specification for Surface Discontinuities of Bolts, Screws, Studs, and Rivets, Inch and Metric Series
F738M-02	Standard Specification for Stainless Steel Metric Bolts, Screws, and Studs
E384-22	Standard Test Method for Microindentation Hardness of Materials
E92-23	Standard Test Methods for Vickers Hardness and Knoop Hardness of Metallic Materials
E18-22	Standard Test Methods for Rockwell Hardness of Metallic Materials
ISO 4027	Hexagon socket set screws with cone point
ISO 4026	Hexagon socket set screws with flat point