ASTM F901-01(2012) - 1.4.2012
 
1. Scope

1.1 This specification covers aluminum structural bolts and nuts for use in the construction of aluminum transmission towers, substations, and similar aluminum structures.

1.2 Diameters of bolts and nuts furnished to this specification are 5/8, ¾, and 7/8 in.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

 
2. Referenced Documents

E101-91

Test Method for Spectrographic Analysis of Aluminum and Aluminum Alloys by the Point-To-Plane Technique (Withdrawn 1996)

F1470-24

Standard Practice for Fastener Sampling for Specified Mechanical Properties and Performance Inspection

F606-14

Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets

B565-20

Standard Test Method for Shear Testing of Aluminum and Aluminum-Alloy Rivets and Cold-Heading Wire and Rods

D3951-18(2023)

Standard Practice for Commercial Packaging

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E227-90(1996)

Standard Test Method for Optical Emission Spectrometric Analysis of Aluminum and Aluminum Alloys by the Point-to-Plane Technique (Withdrawn 2002)

E55-23

Standard Practice for Sampling Wrought Nonferrous Metals and Alloys for Determination of Chemical Composition

E34-11

Standard Test Methods for Chemical Analysis of Aluminum and Aluminum-Base Alloys

MIL-STD-A-8625

Anodic Coatings for Aluminum and Aluminum Alloys Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://dodssp.daps.dla.mil.

B18.2.2

Square and Hex Nuts